I decided to make my own little Arduino Workbench
And here is the result!
All you need is:
A 3mm ABS sheet
3x nuts and bolts
3x spacers
2x Breadboards
9x pads for the bottom
And your favorite Arduino (Mine is from SeeedStudio)
I have created a Arduino Workbench PDF so it is easy to make your own!
Get to work!
Here is my new little robot BennyBlue…
I’ll made my own Android app in Google’s App Inventor.. I was quite easy actually.
It’s controlled serial by receiving characters over my RN-42 Bluetooth module. Yeah, and that’s about it..
Hope you enjoy it! Like it? Comment are appreciated
The source code are available.
BennyBlue is the Android App Inventor source code
Benny_Blue_v1.pde is the Arduino source code
Love to see new robots inspired by BennyBlue 🙂
Enjoy!
I recently decided to make a little shield for a RGB mood lamp. I already had the parts lying around so i started.
Parts:
Arduino compatible board
1 Bare PCB
1 3W RGB LED
5 PIN headers
4 Small wires
1 Power plug
1 ULN2004A Darlington Array
1 8 pin Sockets Solder Tail
3 Resistors – 4.4 Ohm/4.4 Ohm/8.2 Ohm
1 5V wall adapter – Minimum 1A
As you probable can see, there are some additional resistors on the PCB. Thats because I hadn’t the necessary resistors. So i putted 2 x 2.2Ohm resistors in series to make up for the 4.4 Ohm resistor, and I putted a 10Ohm and a 47 Ohm resistor in parallel to make up for the 8.2 Ohm resistor.
I made a schematic so you can see how the wiring goes on
I found some source code from other cool RGB projects, and i decided to post them here:
Candle Light Effect
CrossFader
On/Off RGB
Happy Building…
iLoveArduino 